Description; Installation - Mandik Rdg160T Bedienungsanleitung

DESCRIPTION

MMS control box is used to control gas air heat-
ers MONZUN .
It includes a room thermostat Siemens
RDG160T that is used to control and modulate
the heater, reset button and terminal board .
The heater control can be manual or based on
a week program . Heater performance modula-
tion is automatic in both cases, depending on
the requested and real room temperature .

INSTALLATION

MMS control box is solely designed for interior
use . It is appropriate to situate it on an inter-
nal wall at about 1,5 m above the floor in the
room . Do not install above a heat source (TV,
heater, fridge, etc .) or under direct sun light, in
draught, radiation of devices nor in humid en-
vironment .
Reset button is placed on the left side of con-
trol box . It is used to reset the fault condition
of the burner automation of the MONZUN air
heater, which can be caused, for example, by
unsuccessful ignition when the gas supply is
closed . The fault condition is indicated on the
MONZUN heater by the red indicator light
Alarm
Install the MMC control box using enclosed
screws and dowels in a chosen place .
Pass cable through a gland on the lower side or
through holes in box rear side and connect in
the terminal board pursuant to the fig. 2.
®
MANDÍK, a. s., Dobříšská 550, 267 24 Hostomice | www.mandik.cz
EN
17
|