•
Please note that you may notice a slight sound quality difference
when switching between your BTE microphone program and
your headpiece microphone program�
•
Do not open or close the M Waterproof Battery while in a water
environment�
•
Before placing the Sky CI M in the M Waterproof Battery, visually
inspect the O-Ring seal to make sure it is placed correctly�
Confirm that the O-Ring is not dry, brittle or dirty� If it is, replace
O-Ring prior to use� If damage to the O-Ring is observed or
suspected, replace prior to resuming use�
Inserting the Sound Processor in the M Waterproof Battery
The M Waterproof Battery has a lock to make sure the case is not
accidently opened, preventing moisture from entering the case and
damaging the sound processor. The lock is located on the front of the M
Waterproof Battery.
While holding the M Waterproof Battery in one hand, use your forefinger
on the opposite hand to push the lock button while using your thumb to
pull the lock away from the case.
The M Earhook, M T-Mic, or M Acoustic Earhook, battery, cable, and
headpiece must be removed from the sound processor before inserting
into the case, however the earhook pin can remain in the processor.
Carefully align the battery connector on the sound processor with the
battery connector in the M Waterproof Battery and slide the sound
processor onto the battery connector within the M Waterproof Battery,
connecting the cable connector with the M Waterproof battery to the
sound processor.
39