Distance between
product and battery
Less than 6m (19ft.)
If you want to extend the cord by 6m or more, please contact the
ENGEL service agent.
5) Any switches and lead wire for other electrical equipment
should not be shared with the wiring between your fridge and
battery (other equipment sometimes generates high voltage
pulses which may cause defects in the fridge power supply).
WRONG
6.2.3 Wiring diagram of dual battery hookup
The wiring diagram shown below is recommended for dual battery
hookup.(See Fig 4)
Battery protection
This fridge is equipped with a battery monitor cutting the
compressor in or out in order to protect the battery. When the
"MODE" button is pressed twice, the LED display will be blinking
the current battery monitor state "OFF" or "LO" or "HI" (default
OFF) .
The "SELECT" button during this mode will display the OFF⇒L0⇒
HI change. After pre-setting the battery monitor, the LED display
will stop blinking (after a few seconds) , indicating the temperature
has been set (locked) . The value by each setting is shown on the
below table. The battery monitor is not a necessary feature for the
fridge to operate. It may be left in the off position all the time.
EN
DC 12 VOLT USE
SWG#16 (AWG#14)
/ 2.1mm
BATTERY CHARGER
OR AC/DC CONVERTER ETC
FRIDGE
- 15 -
Wire Gauge
DC 24 VOLT USE
SWG#18 (AWG#16)
or more
/ 1.25mm
2
BATT
GOOD
or more
2
FRIDGE