Operation; Connection To 220V-240V Ac; Connection To 12V Or 24V Dc Battery - Engel MT35F-G3ND-V Benutzerhandbuch

heater or heat generating refrigerator.
Avoid installing your refrigerator close to hot water lines or warm air
ducts.
Adequate ventilation and suitable distance from each wall (at least
150 mm) will enable optimized cooling performance and minimized
power consumption.

6. Operation

Connect only to either of the following power sources:
• 220-240V AC from wall outlet (the mains)
• 12V or 24V DC battery.
AC and DC voltages may be connected simultaneously, when AC
will be automatically selected if both voltages are applied.
NOTICE
Before starting to use your new refrigerator, its interior as well
as exterior shall be thoroughly cleaned with a wet cloth to avoid
hygiene issue.

6.1 Connection to 220V-240V AC

This refrigerator can be connected to a standard domestic power
source by using the three-core lead accompanying the refrigerator.
Insert the plug into the input terminal housing on the refrigerator.
Next, set the temperature setting knob to "0" (OFF). Then, set it
anywhere between 1 and 5. Turn the temperature setting knob to
a required setting.

6.2 Connection to 12V or 24V DC battery

Make sure the battery voltage matches with the voltage stated on
the refrigerator label. If the battery voltage is too high it will
damage the refrigerator.
EN
- 12 -