Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10. Transporting, storing the device
WARNING
Danger of fire caused by hot parts of the equipment. Allow the device to cool
down completely.
• Switch off the device (See „Switching the device on, off)
•
Allow the device to cool down completely
•
Unplug the power supply cable from the device
•
If necessary clean the device (See „Cleaning the device")
•
Lay the device and all disassembled elements into the original article packaging
box and transport of store as specified in the technical specifications. See
technical specifications.
11. Troubleshooting
Problem
Possible cause
The device is switched
Mains cable not plugged in or
on, but does not show any
not plugged in correctly.
function.
Power packs are almost
exhausted
Acoustic feedback mostly
occurs as a high-pitched sound
if a loudspeaker echoes the
signal of a microphone and at
the same time the microphone
records this signal again. The
signal is increased, reproduced
Return to factory settings
via the loudspeaker and there
is an electro-acoustic loop. The
monitor has a loudspeaker box
to reproduce filmed recordings
acoustically at the same time.
Incorrect or abnormal colours:
The device is switched
Check whether the cables are
on, but shows no image:
correctly connected. Defects
Check whether the video
or loose connector pins on
(AV) and HDMI cables are
the cable can lead to a bad
correctly connected.
connection.
38
Remedy
Plug the mains cable in
correctly
Charge the power packs
When filming, feedback can
be avoided in the following
ways: 1. Setting the volume
of the monitors to 0. 2.
Switching to "mute" in the
menu. 3. Using the headset.
4. Ensuring there is sufficient
distance between the mo-
nitor and the microphone. It
is difficult to avoid feedback
when using ODC monitors
with loudspeakers and this
is not a product defect, but a
physical phenomenon.
Aspect ratio is incorrect:
Go to the menu and select
Marker Type: 16:9, 4:3.
2.35:1, 1.85:1 Off. Check the
aspect ratio setting
12. Maintaining the device
WARNING
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
Cleaning
WARNING
Danger of electric shock
■ Do not bring the device into contact with moisture or water.
■ Always pull out the power supply plug before starting to clean the device.
Device
Cleaning
Housing
Use a microfiber cloth to remove light and stubborn dirt.
Display
Do NOT use any chemical solutions such as washing-up liquid
to clean this product. Wipe it with a soft micro-fibre cloth to
buff up the surface.
13. Accessories and options
You find optimal accessories for your device in our webshop.
14. Disposal and environmental protection
Please dispose of your device at your local disposal area at no charge.
15. R eference to the Declaration of Conformity:
"WALSER GmbH & Co. KG. hereby declares that the remote control and
integrated radio receiver are compliant with the general requirements and all
other applicable regulations of the directive 2014/53/EU". The Declaration of
Conformity is available from the following address: info@walser.de
39
Werbung
Inhaltsverzeichnis
