Offgridtec PSI-PRO 12/2000 Benutzerhandbuch Seite 38

4.3 Assembly
To ensure natural thermal convection, you should install the inverter in a place with sufficient aircirculation
and a minimum distance of 150mm from the upper and lower edges of the inverter.
PSI-PRO 12/2000

Schritt 3: Wiring
General information
Offgridtec GmbH
Im Gewerbepark 11
84307 Eggenfelden
WEEE-Reg.-Nr. DE37551 136
Additional ventilation is higly recommended when installed in a housing
The alternating current loads must be determined by the continuous
output power of the inverter. The overvoltage power of the AC load
must be lower than the current surge power of the inverter, or the
inverter is damaged.
• Set the inverter switch to the off status before wiring.
• Do not close the circuit breaker or fuse during wiring. Make sure that the lines of "+" and
"-" poles are correctly polarized.
• A fuse must be installed at the end of the battery, the current of which is 2 to 2.5 times
the rated current of the inverter. The distance between them is not more than 150mm.
The positions of the terminals and connections on the side vary from the inverter models.
•
Contact
Tel: +49 8721 91994-00
Email: info@offgridtec.com
Web: www.offgridtec.com
GFR: Christian & Martin Krannich
Offgridtec PSI-PRO Inverter
Konto Sparkasse Rottal-Inn
Konto: 10188985
BLZ: 74351430
IBAN: DE69743514300010188985
BIC: BYLADEM1EGF (Eggenfelden)
4 Installation
Sitz und Amtsgericht
HRB: 9179 Registergericht Landshut
Steuernummer: 141/134/30045
Ust-IdNr: DE2871 1 1500
Gerichtsstand: Mühldorf am Inn