Samsung RB28F-Serie Handbuch Seite 17

Spacer Spacer
• Remove paper on spacer and then
attach a spacer (Gray block) on the
back side of refrigerator for better
performance. Make sure a spacer
fi x like above image when you install
the refrigerator. It is improving the
refrigerator performance.
(Only for RB31F***B, RB29F***B,
RB37J***9** model)
• Allow suffi cient space to the right, left,
back and top for air circulation.
This will help reduce power
consumption and keep your energy
bills lower.
• Do not install the refrigerator where the
temperature will go below 10 °C.
• Please ensure that appliance can be moved
freely in the event of maintenance & service.
When installing, servicing, or cleaning
behind the refrigerator, be sure to pull the
CAUTION
unit straight out and push back in straight
after fi nishing.
Also, make sure your fl oor supports the
full-load refrigerator.
Otherwise, it may cause fl oor damage.
Please tie up the extra length of the power
cord at the back of the refrigerator so as
CAUTION
not to be touched on the fl oor preventing
the power cord from being crushed by the
rollers upon relocation.
DA68-02833Q-12.indb 17 DA68-02833Q-12.indb 17
All manuals and user guides at all-guides.com
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that has
the same height as the rest of the fl ooring.
This surface should be strong enough to support
Spacer Spacer
a fully loaded refrigerator (or approximately 65 kg).
To protect the fl oor fi nish, cut a large section of the
cardboard carton and place it under the refrigerator
where you are working.
• Pulling or pushing the refrigerator may
damage the fl oor.
Moving the refrigerator after installation
may damage the fl oor.
• When you move the refrigerator, the
Power Cord should be fi xed with the
fi xer of the back side.
setting up _17
2014. 12. 6. 2014. 12. 6. 10:15 10:15