Fellowes Cambio Bedienungsanleitung Seite 4

ASSEMBLING THE DESKTOP
STEP 1
• Attach the anti-vibration pads to the surface of the
crossbar on the 20 positions as shown.
STEP 2
• Align the pre-drilled screw holes with the mounting holes on the crossbar.
Insert and tighten the 4 Phillips Head screws.
• Repeat the same process to tighten the other sides of the desktop.
STEP 3
• Attach the controller to the desktop with 2 Phillips Head screws using a drill.
• Stick the adhesive cable clips under desk to organize cords.
• Repeat the same process to assemble the other controller and cable clips.
STEP 4
• There are two adjustable foot pads under each foot. If the floor is uneven
simply turn the pad to adjust the height to make the desk stable.
Tip: Use a bubble level to check if the desktop is even.
STEP 5
• Plug power cable into controller on base and into a power outlet.
6
CambioBench_411659_RevB_10L_102219.indd 6-7
R
P
1
Q
2
S-B
S
OPERATING INSTRUCTIONS
Downward
Upward
movement
Memory
movement
1/2/3
1. GENERAL OPERATION
When the system is powered on, you will hear a beep and the existing desktop height will be displayed on the controller.
Upward Movement Downward Movement
Press the " " or the " " and do not release until the desk reaches the desired height (displayed on the controller). If the motor continuously operates for a relatively
long period of time, the overheat protection will activate. The control panel will work normally again after approximately 18 minutes.
POWER SAVING MODE - (10 MINUTES)
When no actions are made for over 10 minutes, the system will enter power-saving mode. Touch any button to enter operation mode.
2. MEMORY SETTING
To store a certain height in the controller's memory, first press " ". The letter "S-" will be displayed. Now press " ", " ", or " " within 5 seconds to store the current
height in memory. The " ", " ", or " " buttons can each store a different height. Once in memory, you can select any of the 3 height settings found in the controller's
memory by pressing the corresponding button until the set height is reached. Press any button to cancel adjustment.
3. SCREEN LOCK/UNLOCK
To lock the screen: press " " for 3 seconds and the display shows "---". The screen has been locked and any operation is invalid. To Unlock the screen: press " "
for 3 seconds and the display shows the current height.
Note: Please ensure the auto-lock function is ON. Refer to "PART 5 - Custom Programming Guide" and change the screen lock.
4. TIMER
To set the timer, press " ". The display will flash "0.5h" which means .5 hour. Press the " " repetitively to increase .5 hour at a time. The maximum timer setting is
2 hours. The time is set when the digit stops flashing and the light in the top right corner of the controller is on. When the timer has reached the set time, the buzzer
beeps, reminding the user to adjust his/her working position. The timer will turn off automatically after five beeps. Once a timer setting has expired, the unit's timer
is cancelled. To de-activate the timer, press the " " five times until the current height is displayed and the light found in the upper right side of the controller is off.
5. CHANGING BETWEEN CM AND INCH
The preset measurement shown on the display is cm. If you would like to change the cm to inch, press " " for 8 seconds. After the buzzer beeps twice,
the measurement is successfully reset. If you would like to switch inch back to cm, press " " for 8 seconds. After the buzzer beeps once, the system
successfully switched back to cm.
Indicator Light
Memory/
Timer
Screenlock
Display
(unlock)
10/22/19 4:20 PM
7