geo-FENNEL FIRT 1000 Bedienungsanleitung Seite 18

Switching @ @ @ @ /Ｒ Ｒ Ｒ Ｒ , LOCK ON/OFF and SET ALARM.
p p p p ! ! ! ! @ @ @ @ /Ｒ Ｒ Ｒ Ｒ
q q q q ! ! ! ! LOCK ON/OFF
r! SET ALARM
Select the temperature units (
o o
using the C/ F switch
To lock the unit on for continuous measurement, slide the middle switch
LOCK ON/OFF right. If the trigger is pulled while the unit is lock on, the
laser and backlight will turn on if they have been activated. When the unit
is locked on, the backlight and laser will remain on unless it is turned off
using the Laser/Backlight button on the keypad.
To activate the alarms, please slide the bottom switch SET ALARM right.
To set values for the High Alarm (HAL), Low Alarm (LAL) and Emissivity
(EMS), firstly active the display by pulling the trigger or press the MODE
button, then press the MODE button until the appropriate code appears
in the lower left corner of the display, press the UP and DOWN buttons to
adjust the desired values.
o o
C or F)
9