Denzel ECS-1800P Betriebsanleitung Seite 9

ELECTRIC CHAINSAW
ATTENTION!
Before charging the oil tank de-energize the device.
To fill the oil tank:
1. Be sure to clean the surface around the oil tank cap so that dirt does not get inside.
2. Unscrew the cap of the oil tank 1 (Fig. 8) and fill the chainsaw oil to the MAX mark on the viewing window 2
(Fig. 8).
3. Screw on the cap of the oil tank 1 (Fig. 8).
2
1
Fig. 7
4. Before start working, check the oil supply: Turn on the electric saw and hold it above a suitable object.
With sufficient lubrication, a slight trail of droplets of discharged oil is formed (Fig. 9).
ATTENTION!
Always check the oil level. Operation of the electric chainsaw at an oil level below the MIN mark
is not permitted.
Extension cord connection
To connect the device to a household network, use a quality extension cord by a trusted manufacturer (not included
in the scope of supply).
Before each use, check the extension cord for damage. Do not use extension cords with damaged insulation.
Using extension cords on a reel, make sure that the cord is fully unwound before connecting to the power source.
The cross section must be at least 1.0 mm
Before use, be sure to fasten the extension cord 1 (Fig. 10) using the special holder 2 (Fig. 10). Using the device
with an unsecured cable can lead to a sudden shut-down of the equipment, as well as to various injuries.
Checking chain brake
The saw is equipped with a chain brake, which reduces the likelihood of injury when the saw rebounds.
The safety device is triggered by depressing the brake lever and quickly stops the circuit.
ATTENTION!
The chain brake reduces the likelihood of injury due to a rebound of the saw, but does not provide
protection in the event of careless operation of the device. Before starting work and periodically
during operation, check that the chain brake is operational.
1
max
2
min
Fig. 8
, and the maximum wire length should be no more than 50 meters.
2
Fig. 9
9