Operating Procedure - Denzel ECS-1800P Betriebsanleitung

10
The chain brake 1 (Fig. 11) has two positions:
1. The brake is ON (chain is immovable), when the brake lever is directed forward A (Fig. 11). In this case,
the chain should not move.
2. The brake is OFF (the chain can move) when the brake lever is pulled back and locked B (Fig. 11). In this case,
the chain should move freely along the bar.
1
Checking chain brake:
1. Place the saw on a flat surface and release the chain brake.
2. Start the electric saw.
3. Press the chain brake lever. The chain should stop quickly.
ATTENTION!
The brake lever must be in good condition and generate a characteristic click when moving
from one position to another. Do not use the device if the lever cannot be moved to one of the
positions or the chain does not stop when the brake is applied.
Use of the device
Before starting work, check the workplace and remove foreign objects that could cause various injuries
or damage to the equipment.
Use the device only during daylight hours or in good light conditions. Verify that the mains parameters are within
specifications. Connect the power cable to the extension cord.
To start the device, press the lock button 11 (Fig. 3) and, without releasing it, press the switch lever 12 (Fig. 3).
Be careful when working with the device and always use common sense. In the event of an emergency,
immediately turn off the equipment and contact our authorized service centre.
To turn off the device, release the switch lever and disconnect the device from the power supply.
Trimming branches
ATTENTION!
Do not trim branches while standing on the trunk. This could result in serious injury.
2
Fig. 10

OPERATING PROCEDURE

ELECTRIC CHAINSAW
1
B A
Fig. 11