Troubleshooting - Denzel ECS-1800P Betriebsanleitung

Elektrische kettensäge

Inhaltsverzeichnis

Verfügbare Sprachen

For sharpening, a special holder with a round file ø4 mm must be used. Conventional round files are unsuitable

for this purpose. Sharpening should only be done by moving the file forward (in the direction of the arrow).

When the file moves backward, the pressure on the device should be reduced (Fig. 24).

First, the shortest saw tooth is sharpened. Its length is the specified length for sharpening all other teeth of the saw

chain. The file should be guided as shown in the figure. The file holder makes it easier to handle during

sharpening, it is marked with the correct sharpening angle of 30° (markings should be aligned in the direction

of the saw chain). It limits the penetration depth (4/5 of the file diameter) (Fig. 25).

Even a slight excess of the tooth of the depth gauge must be ground off with a special flat file. The depth gauge

should be rounded in front.

At the end of the grinding process, it is necessary to check the height of the depth gauge using a chain

measuring gauge (Fig. 26).

Fault

The saw does not start.

Increased vibration, noise.

The chain

is not lubricated.

The chain brake does not work.

Maintenance must be carried out at specialized service centres.

30º

Fig. 25

TROUBLESHOOTING

Possible reason

Damage to the power cable.

Damage to the motor or drive

parts.

Start switch is faulty.

No mains voltage.

Extension cord defective.

The motor mount is loose.

Oil pump is damaged.

The oil tank is empty.

The oil filter is clogged.

The brake mechanism is damaged.

Fig. 26

Remedy