Pattfield PSC120M1 Bedienungsanleitung Seite 105

PARALLEL GUIDE
1 Slide the parallel guide into the parallel
guide slide in 11.
CUTTING DEPTH
1 Open the depth clamping knob 3.
CUTTING ANGLE
1 Open the bevel angle adjustment lock
knob 9.
SAW BLADE REPLACEMENT
1 Press the spindle lock button 2.
Caution! Make sure the tool is
switched off and unplugged and
wear protective gloves.
3 Place a new saw blade in the tool.
Caution! Observe that the rotation
direction of the saw blade corre-
sponds with the indication on the tool.
2 Set the desired distance and tighten
the parallel guide clamping knob 8.
2 1. Set the desired cutting depth.
2. Close the depth clamping knob 3.
Make a test on a spare piece before
starting on the workpiece.
2 1. Set the desired bevel angle.
2. Close the bevel angle adjustment
lock knob 9.
Make a test on a spare piece before
starting on the workpiece.
2 Loosen the saw blade clamp
with the hex key and remove the saw
blade.
4 Press the spindle lock button
and tighten the saw blade clamp wash-
er 10 with the hex key.
Caution! The convex surface of the
big washer must point outwards.
washer 10
2 again
EN 105