Midea BOM90D2IX Bedienungsanleitung Seite 120

any button less than 3 seconds, it will stop the audible warning.
Pressing " " for more than 3 seconds set the oven to Manual mode again to use
the oven.
8. Full-automatic programming
This function is used to cook after a certain period of time with a certain duration, The
food to be cooked is put into the oven. The oven is adjusted to the desired cooking
function.The oven temperature is adjusted to the desired degree depending on the
food to be cooked.
First: Press " " button until you see " Dur " on the timer screen. Use " + " " - "
button to adjust cooking period for the food you wish to cook. Press "
confirm, the day's time will appear on the screen and the symbols " A " will begin to
continuously light on the screen.
Second: keep pressing on "
you see " End " on the timer screen, Use " + " " - " button to adjust finishing time, Press
" " button to confirm, the day's time will appear on the screen and the symbol " A
" will begin to continuously light on the screen.The symbol "
time cooking starts.
You can set a time which can be up 23.59 hours after the time obtained by adding the
cooking period to the day's time.
The oven will start operating at the time calculated by deducting the cooking period
from the set finishing time, and will stop at the set finishing time. The timer will give an
audible warning and the symbol "A" will begin to flash.
After bringing the cooking function and oven temperature knob to " 0 " position.
Pressing any button less than 3 seconds, it will stop the audible warning. Pressing "
for more than 3 seconds set the oven to Manual mode again to use the oven.
Please note: Once setting full-automatic mode all the, time can not be changed
Change. Time means cancle automatice progamme and enter into corresponding
mode. If you need to reset automatic mode, need to stop setting the current mode to
set the automatice mode according to the above steps again.
9. Spectification
• When setting the date of each function, long press on " + " or " - " for more than 3
seconds the date will progressively and rapidly increase or decrease.
• When setting each of the time function, if there is none operation for 5 inutes then it
will return to manual mode.
• When setting each of the time function, pressing on "
can cancel current setting and enter manual mode.
• During time function setting, pressing on " + " and "
beep sounds it can cancle the curent time function setting and enter standby mode.
• We suggest that you run the oven elements for 15 minutes at 200 degrees to burn
off any residuce from their surfaces.
 EN-11 
" button until you see " End " on the timer screen. When
" button to
" disappears until the
" for more than 3 seconds
" for more than 3 seconds a
"