Technical Data; Other Precautions; Adjustments And Functions - Felisatti DCHF 13/18R2 Bedienungsanleitung

Two-speed battery-driven hammer drills
Voltage
Battery capacity Ni-Cd
No load speed
Speed 1
Speed 2
Torque Speed 1/2Nm
ø drill in steel
ø drill in wood
ø Max. screw
Drill chuck capacity
Keyless chuck
Hammer
No. of torque settings
Reversible / Electronic
Charging Time
Weight according EPTA-Procedure 01/2003
Noise and vibration
The instructions contained in this manual must be strictly
followed, it should be carefully read and kept close at hand to
use when carrying out maintenance on the indicated parts.
If the machine and charger are used carefully and normal
maintenance is carried out, they will work well for a long
time.
The functions and use of the tool you have bought shall be
only those described in this manual. Any other use of the tool
is strictly forbidden.
ILLUSTRATIONS
DESCRIPTION (See figures)
A Keyless drill chuck (Fig. 1)
B Torque adjustment ring (Fig. 1)
C Speed selector (Fig. 1)
D Forward/reverse switch (Fig. 1)
E On/off/speed adjustment switch (Fig. 1)
F Battery (Fig. 1)
G Battery release button (Fig. 1)
H Screwdriver bit (Fig. 1)
I Battery charger (Fig. 2)
J Charging light (red) (Fig. 2)
K Handle (Fig. 1)
L Lamp (Fig. 1)
M Hole for additional handle (Fig.1)

OTHER PRECAUTIONS

- Always connect the charger to a mains supply pro-
tected by a thermal cut out switch, for your own safety, in
accordance with established safety regulations regarding
low-voltage electrical installations.
- When drilling in walls, ceilings or floors, take care to


TECHNICAL DATA

V
Ah
/min
Nm
mm
mm
mm
mm
h
Kg
dB(A)
avoid electric cables and gas or waterpipes.
• Tightening and loosening screws for metals, screws for
wood, screw that do not require a hole to be drilled previously,
etc.
• Drilling in various types of metal.
• Drilling in various types of wood and plastic.
• Hammer drilling in brick, tiles, and masonry.
Any use that differs from the aforementioned is unau-
thorised.

ADJUSTMENTS AND FUNCTIONS

1. Forward/reverse switch (Fig. 1)
To select the direction of rotation:
• clockwise: push the switch D towards «forward» symbol
on the motor housing.
• anti-clockwise: push the switch D towards «back»
symbol on the motor housing.
The anti-clockwise turn enables screws and nuts to be
loosened.
Warning! Only push the forward/reverse switch D when the
machine is switched off.
2. Electronic speed adjustment (Fig.1)
The speed can be adjusted continuously, not by stages,
according to the pressure exerted on the on/off switch E, from
the machine being switched off to the highest value for both
speeds, as shown in the table.
3. Mechanical speed adjustment (Fig. 1)
These machines are equipped with a two-speed mechanism.
The selector C enables the speed to be adjusted to suit each
use.
DCHF13/18R2
18
2,0
0-350
0-1350
25/23
13
0
8
13
+
+
21
+/+
1
2,
85
USES OF THE MACHINE