Before Starting; Important Safety Precautions; Accessories - Magnat RV 4 Wichtige Hinweise Zur Installation / Garantieurkunde

TABLE OF CONTENTS
8

Accessories

8/9

Before starting

8 Safety precautions
9 Declaration of conformity
9 Use as directed
9 Instructions for disposal
10 Operational elements and connections
10 Front panel
10 Rear/connections
11 Bluetooth®
11 Remote control
11 Initial Operation
12 Tube replacement
12 Service and technical problems
12 Specifications
ACCESSORIES
1) Instruction manual
2) Remote control
3) Batteries for remote control (2x AAA)
4) Mains cable
5) Screwdriver for the remote control
6) Bluetooth® antenna
BEFORE STARTING
Dear customer,
Thank you for choosing the Magnat RV 4 valve amplifier.
Please read the following information carefully before starting to use the RV 4.

IMPORTANT SAFETY PRECAUTIONS

• Please read the instruction manual carefully before use and keep it in a safe place.
• This device is only intended for use with 230 V/50 Hz AC voltage.
• Only operate the device at an ambient/room temperature between 5°C and 30°C.
• A valve amplifier generates a lot of waste heat. Make sure there is sufficient ventilation for the
device. There must be a minimum gap of 10 cm between objects to the side and to the rear. The
area above the amplifier should be as free as possible, however there should be a clear gap of at
least 30 cm to other objects.
• Do not place any objects on top of the device (magazines, CD/record cases, etc.).
• Please do not position any sources of heat, such as radiators, ovens, naked flames or other devices
that generate heat in close proximity to the device.
• The device and the remote control should not be exposed to dripping or splash water or high levels
of humidity.
• No objects filled with liquids, such as vases, shall be places on the unit.
• In the event of contact with moisture or liquids remove the mains adapter immediately.
• Only clean the device using a dry cloth. Do not use any cleaning agents or chemical solvents when
cleaning, as these could damage the surface of the device.
• The mains cable must always be operational. The device should not continue to be operated if
there is visible damage to the mains cable. A damaged cable should not be repaired, but must be
replaced.
• Do not connect or remove the mains cable with damp hands.
• Always refer to a qualified specialist for any maintenance or repair work.
• If the device is not used, it should be switched off at the mains.
• Please remove the mains plug in the event of thunderstorms.
• Only connect the device using a 3-pin power cable with ground wire (earth)! This is part of the
original accessories. Only use this original accessory for the power supply or a power cable that
has been examined with regards to its safety (e.g. with a TÜV or VDE certificate).
8
Autogoods "130"