Operational Elements And Connections; Digital Audio Connections - Magnat RV 4 Wichtige Hinweise Zur Installation / Garantieurkunde

OPERATIONAL ELEMENTS AND CONNECTIONS – FRONT PANEL
1 2 3
1 Power
Switches the device on. The LED (2) illuminates
green. If the device is switched off, it is
completely disconnected from the mains supply.
This switched off state means that the RV 4 does
not consume any electricity at all.
3 Balance control
For adjusting the stereo balance between the
speakers to the right or to the left.
4 Volume
For adjusting the overall volume of the music.
5 Input selector switch SOURCE
Switches between different audio sources:
• Phono MC: Record players with Moving Coil
System (MC).
• Phono MM: Record players with a magnet
system (MM) or MC system with high output
level (high output MC).
• CD: CD player.
• Tuner: Radio reception device.
• Aux: Other audio device (e.g. MP3 player).
• Tape: Tape or cassette recorder.
• Main In: Preamplifier, e. g. Pre-Out of an AV
receiver.
• Digital In (optical/coaxial): Optical / coaxial
digital input for digital audio sources, e. g.
music streamers, CD players, settop boxes,
etc.
4 5 6 7 8
If a digital signal is not available at the selected
input, the message „NO SIGNAL" will appear
in the display.
• Bluetooth: Connection with a Bluetooth device.
6 Display
The following information is indicated in the
display:
• Heating phase of the tubes: WARM UP
• Selected audio input
PHONO MM - PHONO MC - TUNER - CD -
AUX - TAPE - MAIN IN - DIGITL IN (OPTICAL/
COAXIAL) - BLUETOOTH
• Increasing/decreasing volume
• Volume muting: MUTING
• Protect-Mode (in the event of malfunctions):
PROTECT
7 Infrared sensor
When using the remote control it must be aimed
at this sensor.
8 Headphones
6.3 mm stereo output jack for headphones. The
speakers are deactivated when this jack is used.
Set the volume to a low level before connecting
headphones.
OPERATIONAL ELEMENTS AND CONNECTIONS – REAR / CONNECTIONS
R
L
22 21 20 19 18 17
9 Mains connection
For connecting the supplied mains cable. The
safety fuse should only be changed by qualified
service personnel.
10 Speaker terminals
For the connection of stereo speakers with
an impedance rating of 4-8 ohms (the correct
polarity must be taken into account).
11 BT Antenna
Connection for the Bluetooth antenna. Screw
the supplied Bluetooth antenna here and align
it vertically

DIGITAL AUDIO CONNECTIONS

12 Digital inputs (optial and coaxial)
For connecting digital audio devices with a
optical or digital cable.
ANALOGUE RCA CONNECTIONS
For connecting analogue audio devices. Please
observe the coloured marking of the sockets and
connectors. Red is always the right channel.
13 MAIN IN
Power amplifier input for connecting an external
preamplifier or preamplifier outputs of an AV
receiver. The volume level is controlled by
10
Autogoods "130"
SPEAKER OUT
BT
OPTICAL COAXIAL ANTENNA
16 15 14 13 12 11 10
the external preamp. Balance control (3) and
volume control (4) have no function for the RV 4.
14 PRE Out
Preamplifier output for connecting an external
power amplifier or a powered subwoofer. The
output level depends on the position of the
volume knob.
15 REC Out
For connecting devices for analogue sound
recording (e.g. tape recorder). The signal for the
selected audio source with fixed level applies for
this output, i.e. it is independent of the position
of the volume knob.
16 TAPE input
For the connection of a cassette deck or tape
recorder.
17 AUX input
Connection of another audio source (e.g. MP3
or Minidisc player).
18 TUNER input
Connection of a radio reception device.
19 CD input
Connection of a CD player.
9