Maintenance And Care; Disassembly; Warranty; Disposal - GLATZ Suncomfort Pendolino Gebrauchsanweisung

Maintenance and care

• Allow the sunshade to dry when open to prevent the formation of
mould and discolouration.
• A protective sleeve protects the sunshade and will extend its ser-
vice life.
• Only pull the protective sleeve over the dry sunshade when it is dry.
• Clean the protective sleeve and the sunshade cover when needed
with lukewarm water and a sponge.
• Do not use any bleach or sharp objects, to avoid damage to the
cover.
• Check the tightness of all screws from time to time and tighten
them if necessary.
• If the sunshade is located in a highly exposed position, increased
wear and tear must be expected. In such cases we recommend
more intensive care and maintenance.
• In most cases, defective sunshades can be repaired by your SUN-
COMFORT/GLATZ partner. Only use original replacement parts
from SUNCOMFORT/GLATZ.

Disassembly

Disassemble the sunshade if it is not going to be used for a longer
period. WARNING! DANGER OF TIPPING. DANGER OF INJURY CAUSED
BY SUNSHADE TIPPING OVER.
1 Close the sunshade correctly and tie up.
2 Take the sunshade out of the base / ground socket and lay it down.
3 Store the sunshade in a lying position along with all accessories in
a dry place.
40 41

Warranty

Please contact your SUNCOMFORT/GLATZ partner before returning
the product. The warranty on the sunshade lasts for 24 months from
the date of purchase. The warranty expires in the following cases:
• External application of excessive force
• Inappropriate operation or maintenance of the sunshade
• Damage arising from force majeure
The wind guarantee for an open sunshade is limited. If there are
several sunshades, a minimum distance of 20 cm must be main-
tained between any two of them. Likewise, a minimum distance of
20 cm must be maintained between the sunshade and walls.

Disposal

Dispose of the product in a recycling collection point intended for
this purpose. By correctly disposing of the product, you are helping
to prevent possible dangers for the environment and for health
which can be caused by incorrect disposal of old devices. The pack-
aging is made from environmentally friendly materials which can
be disposed of in your local recycling facility. The product consists of
metal and plastic parts. Disposal at the end of service life must be
carried out under the terms of the regional environment and waste
regulations.