Installation And Set-Up - GLATZ Suncomfort Pendolino Gebrauchsanweisung

Installation and start-up
1
2
3
Unpacking the sunshade
Supplied with:
- Sunshade
- Crank
- Protective cover
- Operating instructions
- Cross base with stand pipe, mounting
material
!
Dispose of packaging material proper-
ly and keep away from children.
Do not make use of defective material.
In the event of any damage, inform the
transport service provider immediately.
Placing the sunshade down
!
Carefully place the sunshade on
a clean, horizontal surface. The
sunshade is very heavy. Work in a
threesome and hold the sunshade
securely.
Prepare the floor fastening
Place the floor fastening in accordance
with the separate instructions.
or...
36 37
3.1
3.3
5.1
Prepare the floor fastening
Floor fastening weights and wind
resistance
Size
[cm]
40 x 40 x 4
3.2
1. Mount cross base
2. Place stand pipe on cross base
3. Adjust holes / position
4. Place 4 washers in position
5. Pre-assemble standpipe with
4 round-headed screws (M8 × 20mm)
4
Pre-assemble sunshade
1. Put the crank in place and
screw tightly
5
Place sunshade
1. Put the pole up and place it into its
anchorage system (ground socket/ base)
2. Tighten the base tube clamp
i
Suitable floor mounts are available
from your SUNCOMFORT/GLATZ
5.2
dealer.
minimum weight
[kg]
120