CHROMOnorm 410-Serie Betriebsanleitung Seite 16

For this purpose, the machine compartment must be opened. The machine compartment
cover is secured at the bottom with a screw and can be swiveled upwards after removing
the fastening screw. The lamellae of the condenser are now easily accessible and can be
cleaned.
For cleaning
• Before cleaning, switch off the appliance and pull the mains plug.
• Remove food from the appliance and store in a suitable place.
• Wear suitable gloves (eg nitrile rubber) during cleaning work to prevent skin
irritation.
• Choose cleansing products with a sufficient cleansing effect in the case of protein
and fats.
• Remove racks.
• Check that the hole in the drainage channel is free from contamination.
• Clean the corpus, inside surfaces and gaskets with a microfiber cloth that is
repeatedly washed out in the cleaning liquor.
• Areas that come directly into contact with food, wipe with clear water.
• All surfaces are allowed to dry.
• When using surface disinfectants, the respective exposure time must be observed.
The exposure time must not be interrupted by prematurely wiping or rubbing the
surfaces dry.
• Turn the appliance on again and place it again after reaching the desired
temperature.
With opened machine compartment cover:
Picture 2
Picture 3
• Panel of the installation compartment can be
opened by loosening the fastening screw.
• The wiring diagram is located at the left side
behind the installation compartment panel.
• Condenser (liquefier)
• Ribs can be easily cleaned with opened installation
compartment panel. See chapter 6 „Cleaning and care"
• You will find the nameplate on the right side
16