CHROMOnorm 410-Serie Betriebsanleitung Seite 13

Display indications
LED
Compressor on
Defrost or pre-dripping
active
Evaporator fan on
Saved HACCP-Alarm in
HACCP
EVlink
Energy Saving active
Request for compressor
service
°C/°F View temperature
AUX Auxiliary load on
Device off
Switching the device on/off
- Touch the ON/Stand-by key for 4 sec.
If the divice is switched on, the display will show the cabinet temperature by default.
If the display shows an alarm code, see the section 3.3 ALARMS.
If Loc = 1 (default) and 30 sec. have elapsed without the keys being pressed, the display
will show the ``Loc`` label and keypad will lock automatically.
Unlock keypad
Touch a key for 1 sec.: the display will show the label ``UnL``
Set the setpoint
Check that the keypad is not locked.
1.
2.
3.
Defrosting
All devices have fully automatic defrost regulation. The parameters for defrost intervals,
defrost times etc. have been factory-set to the optimal values. These parameters can only
be changed in exceptional cases by an authorized refrigeration company. The parameter
lists will be made available by the manufacturer if necessary. During the defrosting phase,
the controller display will show
completion. Condensate evaporates automatically in all devices using hot gas.
ON OFF
Compressor off
Evaporator fan off
Auxiliary load off
Device on
Touch the SET key
Touch the UP or DOWN key within 15 sec. to set the value
Touch the SET key (or do not operate for 15 sec.)
it informs the defrosting phase and disappears after its
FLASHING
- Compressor protection active
- Setpoint setting active
- Defrost delay active
- Dripping active
- Evaporator fan stop active
- Settings active
- Access to additional functions active
- Operation with EVconnect APP active
- Overcooling or overheating active
- Auxiliary load on by digital input
- Auxiliary load delay active
- Device on/off active
13