Adjusting The Feet; Changing The Illumination Lamp - Beko DC8230A1 Bedienungsanleitung

C
NOTE
• Make sure that the discharge hose is tight
after it is connected to the drain in order
to obtain a better water flow since the
machine is not equipped with a pump.
You can cut and shorten the hose to
adjust its length if necessary.
• The end of the hose should never be
higher than the level of the water outlet
on the machine. Otherwise, the "tank full"
light of your machine will illuminate and
stop the programme.
• If the dryer is mounted on the washing
machine by means of a bracket, use of
the water drain hose is recommended.
The drain hose should be directed
downwards as shown in the figure.

3.4 Adjusting the feet

3.5 Transportation of the dryer
Drain all water that has remained in the dryer.
If direct water drain connection is made, then
remove the hose connections.
A
WARNING!
• We recommend carrying the dryer in
upright position. If it is not possible to
carry the machine in the upright position,
we recommend carrying it by tilting
towards the right side when looked from
the front.

3.6 Changing the illumination lamp

In case an illumination lamp is used in your
laundry dryer.To change the Bulb/LED used
for illumination of your tumble dryer, call your
Authorized Service.The lamp(s) used in this
appliance is not suitable for household room
illumination. The intended purpose of this
lamp is to assist the user to place laundry in
the tumble dryer in a comfortable way. The
lamps used in this appliance have to withstand
extreme physical conditions such as vibrations
and temperatures above 50 °C
Dryer / User Manual
Turn the feet to left
or right until the
dryer stands level
and firmly.
33