Appropriate Installation Location; Connecting To The Drain - Beko DC8230A1 Bedienungsanleitung

3 Installation
Before the calling the nearest Authorized
Service for the installation of the dryer, ensure
that electrical installation and water drain is
appropriate referring to the user's manual.
If they are not suitable, contact a qualified
electrician and technician to make necessary
arrangements.
C
NOTE
• Preparation of the dryer's location
as well as the electrical and waste
water installations is under customer's
responsibility.
A
WARNING!
• Prior to installation, visually check if the
dryer has any defects on it. If the drier
is damaged, do not have it installed.
Damaged products cause risks for your
safety.

3.1 Appropriate installation location

Install the dryer on a stable and level surface.
Dryer is heavy. Do not move it by yourself.
• Operate your dryer in a well ventilated,
dust-free environment.
• The gap between the dryer and the
surface should not be reduced by the
materials such as carpet, wood and tape.
• Do not cover the ventilation grills of the
dryer.
• There must not be a lockable, sliding or
hinged door that may block the opening
of the loading door in the place where
your dryer is to be installed.
• Once the dryer is installed, it should stay
at the same place where its connections
have been made. When installing the
dryer, make sure that its rear wall does
not touch anywhere (tap, socket, etc.).
• Place the dryer at least 1 cm away from
the edges of other furniture.
• Your dryer can be operated at
temperatures between +5°C and +35°C.
If the operating conditions fall outside
of this range, operation of the dryer will
be adversely affected and it can get
damaged.
32
• The rear surface of the tumble dryer shall
be placed against a wall.
B
DANGER!
• Do not place the dryer on the power
cable.
3.2 Removing the transportation
safety assembly
A
WARNING!

3.3 Connecting to the drain

Connection pipe to water drain is at the bottom
rear of your machine.
A
WARNING!
In case of removing the drain hose, do not
forget to replace the rubber cap and bracket
to its position back.
• Remove the
transportation
safety assembly
before using the
dryer for the first
time.
• If the door swing
side of your
appliance can
be modified, see
the reversible
door mounting
instructions.
1. Remove the
bracket and
the rubber cap.
2. Attach the drain
hose and
replace the
bracket to its
position.
Dryer / User Manual