Automatic Restart - Husqvarna LC 247i Bedienungsanweisung

To use the drive on the wheels
LC 347iVX, LC 353iVX
• Pull the drive bail in the direction of the handlebar to
start the drive.
• Push + and - on the control panel to set the drive
speed in 4 steps.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To use the SavE
The product has a battery saving function (SavE
gives longer operation time.
™
• Push the SavE button to position 1 to start the
function.
™
• Push the SavE button to position 0 to stop the
function.
Note:
™
The SavE function stops automatically if the
ground conditions make it necessary to have a higher
1696 - 003 - 16.12.2021
™
function (LC 247i)
output. The SavE
when the ground conditions let it.
To use the SavE
(LC 347iVX, LC 353iVX)
The product has a battery saving function (SavE
gives longer operation time.
1. Push the SavE
™
SavE
2. Push the SavE
The SavE
Note:
The SavE
ground conditions make it necessary to have a higher
output. The SavE
when the ground conditions let it.
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
™
) that
standard mode when high load is not necessary.

Automatic restart

During operation, the blade and motor can temporarily
stop because of obstacles such as grass blockage
below the cutting cover. If this occurs and you keep the
motor brake handle pushed down, the product tries to
restart automatically. If the product does not restart in 5
seconds, it can be necessary to clean below the cutting
cover. Refer to
™
function starts automatically again
™
function
™
button (A) to start the function. The
symbol (B) on the display comes on.
™
button again to stop the function.
™
symbol (B) on the display goes out.
™
function stops automatically if the
™
function starts automatically again
To clean the product on page 18 .
WARNING:
Before a check of the
cutting cover, release the motor brake
handle, turn the safety key to 0, remove
the battery and wait at minimum 5 seconds.
There is a risk of injury if the obstacle is
removed and the product accidentally starts.
™
) that
B
A
15