Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembling to the wall:
1)
Place the black spacers into the open ends of the foot positioner. The spacer must
be placed with the long distance piece on the side with the boreholes.
2)
Push the foot positioner gently into the designated lower end of the measuring rod.
Fix same with the two small screws.
Measuring Rod
3)
Select a plane and level location at the wall.
4)
Pull out the measuring rod until both boreholes are free.
5)
Place the measuring rod with a water-level vertical at the wall.
6)
Mark the drill holes at the wall through the wholes at the measuring rod.
7)
Drill using a matching drill bit.
8)
Insert the two anchors into the wall.
9)
Insert now the two long screws through the holes into the measuring rod.
10) Put the round spacers over the screws between the rod and the wall.
11) Screw the screws into the anchors very tightly.
12) The foot positioner must be supported against the wall by the two black spacers.
Safety advice
Follow the instructions of the Operating Manual.
After finishing the measurement make sure to fold the measuring tongue down to avoid
danger of injury.
Operating Instructions
1)
Adjust the measuring tongue to a horizontal position.
2)
Slide the measuring tongue up to over the length of the person to be measured.
3)
Place the person to be measured under the measuring tongue.
4)
Slide the measuring tongue down to the person's head.
5)
Take the result from the readout point.
6
Installation
Spacer
Foot positioner
MZ10023-3-210420-Rev002-UM-de-e-fr-nl
Werbung
