Alarm Setting; Temperature Displays - Technoline WS9767 Bedienungsanleitung

ALARM SETTING


Press and hold the ALARM button for 2 seconds, the AL icon appears on the display, the hour digits flash. Press the
SET/RESET button to set the desired alarm hours.

Press the ALARM button again, the minute digits flash. Press the SET/RESET button to set the desired alarm minutes.

Press the ALARM button again to store the alarm settings and return to normal time display. The clock will return to normal mode
in around 30 seconds if no further press of any other buttons.
Turn on or off the alarm
Single press the SET/RESET button during normal time display to turn on or off the alarm. When the alarm function is turned on the
icon appears on the display on top of the time digits.
Snooze function
When time reaches the set alarm time, the station will give a beep sound to wake you up. The

Press the SNOOZE/CH/REGISTER button once to stop the alarm temporarily, the snooze icon Zz keeps flashing. The alarm will
beep again after snooze duration of 6 minutes.

To stop the alarm, press any button except the SNOOZE/CH/REGISTER button when alarm is beeping. The snooze icon Zz
disappears. The alarm will beep again same time next day.
Note: Alarm duration is approximately 2 minutes.

TEMPERATURE DISPLAYS

The INDOOR temperature displays the temperature of the location of the temperature station.
The OUTDOOR temperature displays the temperature of the location of the outdoor temperature sensors (outdoor area or another
indoor rooms p.e. cellar, loft, etc.).
Outdoor transmitter reception and signal indicator
After the station is powered up, it starts to search for outdoor transmitter signal. The
outdoor transmitter signal manually, press and hold the SNOOZE/CH/REGISTER button for 2 seconds.
Receiving signal
Successful reception
Failed reception
Press the SNOOZE/CH/REGISTER button once to display continually the temperature of only one outdoor sensor (1 channel).
Press the SNOOZE/CH/REGISTER button repeatedly to display sequentially the temperatures of all outdoor sensors (channel 1, 2
and 3).
Press the SNOOZE/CH/REGISTER button repeatedly until the
between all 3 outdoor sensor channels (channel 1, 2 and 3). Press the SNOOZE/CH/REGISTER button to cancel.
°C/°F Display
Press and hold the SELECT button for 2 seconds, the temperature display format °C/°F flashes. Press the SET/RESET button to
select the °C (Celsius) or °F (Fahrenheit) temperature display format. Press the SELECT button again to store the setting.
Temperature trend indicator
The indoor and outdoor temperature trend indicators are updated every 30 minutes. These trend indicators represent the
temperature changes over the past three hours:
Temperature rose more than 1°C (2°F) in the past three hours.
Temperature has not changed more than 1°C (2°F) in the past three hours.
Temperature fell off more than 1°C (2°F) in the past three hours.
( icon flashing)
( icon becomes static)
( icon disappear)
icon is shown. The temperature display will switch automatically
GB 2
icon will flash.
icon flashes. To start the reception of