Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SP13 "M"
Warning: In order to keep the appliance fully functional, the polyester filter car-
tridge must be shaken after every use.
Warning: it is forbidden tampering the appliance. Failure to comply with these
instruction could cause serious accidents and damages to the user, that can
also lead to death.
The manufacturer declines all responsibility for damages or injuries due to im-
proper use of the machine or caused by the failure to respect the instructions
given in this manual.
ELECTRICAL PARTS - FEATURES - STARTING UP
A1
Red general switch.
Position "0"
appliance off -
A2
Additional socket to connect the power tool.
Warning: the additional socket is always under power when the machine is
connected to electrical main.
When using power-tools, do not exceed the power reported on the additional
socket. Check that the power-tool voltage corresponds to what is stated on the
technical data plate on the vacuum cleaner. Failure to comply with these instruc-
tion could cause serious accidents and damages to the user, that can also lead
to death. Connect the plug to a receptacle that is connected to the electrical
ground.
Warning: Before connecting the power tool, make sure that it is off.
Warning: Before turning off the appliance, make sure that the power tool is off.
At the end of a cleaning session turn off the vacuum and remove the plug from
the socket.
A3
Light indicator connected to a pressure switch, it turns on when the filter cartridge is clogged
and it must be replaced.
A8
General switch I - 0 - II
Position "I"
: Only the vacuum cleaner can work.
Position"0"
: Automatic mode: power tool + vacuum + automatic filter shaker.
Vacuum cleaner turns on or off automatically depending on whether or not the power tool is on or off
(Max power - see label on the additional socket).
If you turn off the power tool, after 8 seconds the motor of the vacuum cleaner will turn off and an the
filter shaker will perform an automatic cleaning cycle that will last 15 seconds.
NB: If throughout the cleaning cycle you turn on the power tool, the shaker will automatically stops
and the vacuum cleaner will start.
Position "II"
: Only the filter shaker works, in manual mode.
Stop the vacuum cleaner before shaking the filter. In this position the user can shake the main filter by
pushing the switch in position "II" for a lapse of 15 seconds at the most. The minimum time between
one use and the following is 2/3 minutes.
16
Position "I"
appliance on.
Werbung
Inhaltsverzeichnis
