Attachment; Use - MAXXMEE 02702 Bedienungsanleitung

Compact Steam Brush
5. Reinsert the water tank cap. Make
sure that the water tank is fi rmly
sealed shut.
6. Place the water tank back on the main
unit and press it down fi rmly. You
must feel it engage.

ATTACHMENT

Please Note!
■
Shortly after use, the attachment
used may still be very hot. Wait until
the device and the attachment used
have cooled down completely before
removing them.
• The brush attachment (6) is suitable
for freshening up home textiles such
as upholstery, curtains etc. (Picture E).
• Attaching: Place the attachment
with the locking lug at the bottom
on the steam bottom and press it
fi rmly upwards. The attachment must
engage audibly.
• Removing: Pull the tab on the bottom
of the attachment forwards and
remove the attachment (Picture D).

USE

Please Note!
■
Before using the device, read the care
instructions for the fabric which is to
be smoothed. Some fabrics such as
leather and suede as well as fabrics
with fl ounces, sequins and appliqués
must not be steamed!
■
Do not guide the steam bottom over
zips, studs, clips etc. to prevent any
scratching.
■
Never use in front of surfaces made
from glass or plastic.
■
There must be suffi cient clear space
around the item of clothing which is
to be smoothed.
■
Danger of scalding! Only use the
device when the control lamp is
green. The operating temperature
has then been reached. If the device
is used before this, hot water may
escape.
1. If you wish, mount the brush
attachment (6) (see the "Attachment"
chapter).
2. Pour water into the water tank (7) (see
the "Filling the Water Tank" chapter).
3. Plug the mains plug into a plug
socket. The control lamp (5) lights up
red and the device starts to heat up.
When the control lamp is lit green, the
device is ready to operate.
4. Move the steam brush in strokes over
the fabric and press the steam release
button (3) at regular intervals as you
do so. It is important for the steam
bottom (4) or the brush attachment to
touch the fabric so that it is freshened
up (Picture E and F).
5. If steam stops being produced, the
water tank is empty. Allow the device
to cool down for a few minutes and
refi ll the water tank (see the "Filling
the Water Tank" chapter).
 
If the control lamp turns red
during use, the device is
reheating. Let go of the steam
release button if you do not want
to continue the heating process
and want to prevent a danger of
scalding from hot water which
may escape. Wait until the control
lamp is green again.
EN
15