Filter Replacement; Troubleshooting - getAir LED Montage- & Bedienungsanleitung

All manuals and user guides at all-guides.com

5.4 Filter replacement

The control unit determines when the filter
should be replaced, depending on the re-
quired air flow rate. As soon as a filter re-
quires replacement, the LEDs flash steadily.
Pressing the two round buttons in the mid-
dle confirms filter replacement and resets
the interval.

6 Troubleshooting

Fault
Fan not
responding.
LEDs flashing
steadily.
Cause
Installation or mainte-
nance fault.
Filter replacement
interval elapsed.
INFORMATION
The optimum time until filter replacement
can vary depending on local environmental
influences.
Solution
• Check the cabling to the fan and
control unit.
Check the filter; replace if necessary.
•
• Press the two middle buttons to
confirm filter replacement.
31