Dip Switch - getAir LED Montage- & Bedienungsanleitung

All manuals and user guides at all-guides.com

4.3 DIP switch

The fans have a DIP switch on the top. Dur-
ing installation, this must be configured
according to the design, so that the control
unit and fans can communicate.
1 Switch 1 - 3: zone 1 – 3
(up = ON, down = OFF).
2 Switch 4: start direction
(up = extract air; down = supply air).
1 2
INFORMATION
When setting the zone, you may enable only
one zone switch. The other two zone switches
must be disabled.
INFORMATION
The LED control unit does not support zone
regulation. Switch 1 must therefore always be
enabled for zone 1.
CAUTION
Risk of over/underpressure!
In each zone, the start directions must offset
the number of fans.
• Check the fourth switch of each fan in a
zone and offset the number of both start
directions if necessary.
29