Seite 1
All manuals and user guides at all-guides.com M o n t a g e a n l e i t u n g f ü r B a u s a t z W A R N B L I N K A N L A G E H 0 5 4 9 1 Ω...
Seite 2
All manuals and user guides at all-guides.com ð ð ð ð ð ð ð ð ð ð ð...
Seite 3
All manuals and user guides at all-guides.com...
Seite 4
All manuals and user guides at all-guides.com...
Seite 5
(14 - 16 V) and is in compliance with EN 60 742. row top, a fine rope of soldering ore, in- Not siutable for children under 8 years of age. stant glue (Busch 7597) and white enamel Please retain these instructions. paint.
Seite 6
All manuals and user guides at all-guides.com Safety advices: LEDs 1. Provide sufficient air ventilation while working with glues -caution- glue may be hazardous to health! 2. All electronic parts contained in this kit marking must be connected to low tensions only grey red (max.
Seite 7
Apply transistors (13) in same manner before A more comfortable and convenient method is achieved by use of Busch IR- putting elkos in position. These parts are also marked appropriately and the shorter units in connection with a timer (Busch wire is your negative pole.
Seite 8
All manuals and user guides at all-guides.com Refer to pic. 6 for proper installation of ouflaged by use of irish moss or other ma- blinkers and timer (Busch # 5963). terials to keep out of sight. An IR-unit consists of a transmitter emit- Convenience is gained by the latter method ting infra-red rays of light and a receiver.