Preparing To Charge - LEMANIA ENERGY FLASH Serie Bedienungsanleitung

Ladegerät / battery support

Inhaltsverzeichnis

Verfügbare Sprachen

If battery acid enters in contact with your eyes, skin or clothing, wash immediately with soap and water. If acid enters in contact

1.10

with your eyes, immediately flush them with running cold water for at least 10 minutes and get medical attention immediately.

Remove personal metal items when working near engines/motors & batteries.

1.11

Always read the vehicle's user manual before connecting any charger to the vehicle or its battery.

1.12

Do not attempt to charge a marine (boat) battery while the boat is on or near the water. A boat must be on a trailer and located

1.13

indoors before attempting to charge its battery(s). The boat manufacturer's instructions must be followed exactly.

To reduce risk of damage to the electric plug and cord, pull the plug rather than the cord when disconnecting the charger

1.14

An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire

1.15

and electric shock. If an extension cord must be used, make sure that the pins on plug of the extension are the same as on the

charger, and that the extension cord is properly wired and in good electrical condition. The wire size must be large enough and

related to the A.C. amperage rating of the charger.

If this device has been dropped, is damaged or is leaking, please have it controlled right away by an authorized agent.

1.16

Appliances containing batteries which contain hazardous materials for the environment:

1.17

Batteries contain lead and dilute sulfuric acid. Dispose of the battery in accordance with federal, state and local regulations.

Do not dispose of the battery in a landfill, lake or natural environment. It must be recycled properly.

Scrap and replace the VRLA battery at or before the time indicated on the battery or in the user's manual. Usage beyond

the required time of service can cause fluid leakage due to damages to the container, or cause fire due to power leakage.

When the battery charger is charging a vehicle's battery, the following steps should be done:

1.18

The battery terminal that is not connected to the chassis has to be connected first. The other connection is to be made to

the chassis, away from the battery and fuel line. The battery charger is then to be connected to the supply mains.

After charging, disconnect the battery charger from the supply mains, and then remove the chassis connection before the

battery connection, in this order.

NEVER smoke, allow a spark or flame in vicinity of battery or engine.

1.19

Do not use the battery charger for recharging dry-cell or non-rechargeable batteries that are commonly used with home

1.20

appliances. These batteries may burst and cause personal injuries and/or property damages.

NEVER charge an inappropriate type of battery, or an inappropriate voltage.

1.21

Always store the clamps correctly after each use.

1.22

- Battery acid and gases can be dangerous, never touch or inhale them. Be careful when operating inside engine bays.

1.23

Moving parts may cause injuries. Never use this device to start or recharge a frozen (very cold) battery. It could be very

dangerous.

- Always check the voltage of the vehicle's battery before trying to recharge it.

1.24

- Please recycle this device, batteries and their packaging properly. Always keep the device at room temperature (15-25°C).

1.25