LEMANIA ENERGY FLASH Serie Bedienungsanleitung Seite 12

5 DIAGNOSTIC MODE (POWER SUPPLY MODE)
The charger will act as a stable, configurable power supply during vehicle diagnostics, repair and module programming.
Output voltage control:
Output Current Control: 5~150Amp adjustable for the SF150 units / 1-35Amp adjustable for the SF35 units.
6 SHOWROOM MODE (POWER SUPPLY MODE)
Supply power to, and maintain the battery of vehicles in demonstration mode:
Step 1:
Step 2: Press
Step3: Press
Displayed values during diagnostics:
Load percentage: displays the load on the charger (%)
Current: displays the output current (A)
Voltage: displays the output voltage (V)
Watt: displays the output power (W)
Time: displays the duration
12~15v (x2 for 24V mode) adjustable
Step 1:
Step 2: Press
Step3: Press
Press to Enter or Exit this Mode.
to Select the desired parameters:
Battery Voltage; Output voltage, Maximum Output Current.
to Start or Stop the mode.
Press to Enter or Exit the mode.
to Select the desired parameter:
Battery Voltage; Output voltage, Output current.
to Start or Stop Showroom mode.
12