Electrical Connection; Work Before Start-Up; Operating; Start/Stop - Zipper Maschinen ZI-WP400TN Betriebsanleitung

14.4 Electrical connection

 Connect the machine to a standard 230V±10% (50Hz±1Hz) power supply equipped with
protections for undervoltage, overvoltage, overcurrent and a residual current device (RCD)
with a maximum residual current of 0.03A.
 The plug of the machine must fit into the socket. The plug must not be modified in any way.
Do not use adapter plugs together with protectively earthed machines. Unmodified plugs and
matching sockets reduce the risk of electric shock.
 Only use extension cords that are also suitable for outdoor use. Using an extension cord
suitable for outdoor use reduces the risk of electric shock.
15 OPERATION

15.1 Work before start-up

 Make sure that the saw blade is firmly secured, in perfect condition, sharpened and guaranteed
to run smoothly.
 Make sure that the rocker unit with the log carriage is fully extended before each use. Other-
wise there is an increased risk of recoil.
 When cutting material, pay attention to foreign objects such as wires, nails, etc. as well as
irregularities in the material, such as knots.
 Check that the moving parts are working properly and are not jammed.
 Ensure that the machine is securely anchored to the ground.
 Ensure that the correct power supply and cable are used. Insert the plug into the socket.

15.2 Operating

15.2.1

Start/Stop

To start the machine, press the green button ˝I˝ on the ON-OFF switch.
To stop, press the red button ˝O˝.
15.2.2

Workflow

1. Switch on the machine.
2. Open the top guard.
3. Position the cut material into the log carriage on the completely extended rocker unit.
4. Close the top guard again.
5. Grasp the handle on the left side of the carriage and slide it towards the saw blade cover.
6. Continue pressing with even force until the cut material has been cut.
7. After the cut, move the log carriage all the way back again.
8. If necessary, reposition the cut material and repeat steps 4 to 7 until the work is finished.
9. Switch off the machine after work.
10. Wait until the machine stops.
11. Disconnect the power plug and clean the unit if necessary.
Free blocked log
If the saw blade is blocked, proceed as follows:
1. Switch off the machine immediately!
2. Wait until the machine comes to a standstill
3. Pull out power plug.
4. Carefully remove the blocked log from the machine.
ZIPPER MASCHINEN GmbH
ZI-WP400TN
www.Zipper-Maschinen.at
OPERATION
34