Werock Scoria A10X Bedienungsanleitung Seite 67

1. Insert tabulator character before the barcode
2. Insert tabulator character after the barcode
3. Execute line break (Carriage Return / Enter) after the barcode
You can also combine tab and carriage return.
To make the settings, proceed as follows:
Insert tab character before or after the barcode.
1. In the Scanner Configuration app, tap the gear icon in the upper right corner.
2. Then tap on "General Settings
3. Then tap on "Tab" and select the desired property:
4. "Add in front" adds a tab control character in front of the barcode
5. "Add behind" adds a tab control character after the barcode
6. "Close" does not add a tab control character barcode
7. Finally, confirm the input by pressing "Sure".
Execute line break (Carriage Return / Enter) after the barcode
1. In the Scanner Configuration app, tap the gear icon in the upper right corner.
2. Then tap on "General Settings
3. Now tap on the toggle switch at "enter" so that it is highlighted in green.
Selection of the barcode types used
Disabling supported barcode types can be useful to increase the performance of the integrated scanner and
reduce erroneous scans. To do this, proceed as follows:
1. Open the "Scanner Configuration" app and tap on the gear icon in the upper right corner.
2. Then tap on "Symbologies
3. In the overview, select the barcode types you are using. The toggle on the right side is highlighted in
green if the corresponding type is activated. Tap on the toggle switch to activate or deactivate the
recognition.
The changes are applied immediately.
Confirmation of the successful reading process
To let you know when your barcode has been successfully captured, you can receive a confirmation from the
Scoria A100. There is the option to receive a beep as well as a short vibration or both. To make these
settings, proceed as follows:
1. In the Scanner Configuration app, tap the gear icon in the upper right corner.
2. Then tap on "General Settings
3. To activate an acoustic notification Tap on the toggle switch at "sound" so that it is highlighted in green.
4. To activate a haptic notification Tap on the toggle switch at "vibrate" so that it is marked green.
The changes are applied immediately.
Activate picklist mode
Picklist mode allows the digital scanner to decode only barcodes that are aligned under the exact LED
aiming point. It allows the user to select and scan a single barcode from an array of barcodes.
1. In the Scanner Configuration app, tap the gear icon in the upper right corner.
2. Then tap on "General Settings"
3. To enable Picklist Mode, tap the toggle switch at "Picklist Mode" so that
The changes are applied immediately.
Scoria A10X User Manual
67 / 74