Werock Scoria A10X Bedienungsanleitung Seite 66

Scoria A10X User Manual
Automatic start of the barcode scanner at system startup
1. In the Scanner Configuration app, tap the gear icon in the upper right corner.
2. Then tap on "Setting
3. Then tap on "Auto start Service" so that the toggle switch is highlighted in green.
The next time the device is started, the application will now start automatically.
This function was removed with the release of the Scanner Configuration App software version 1.2.9. The
application now starts on the system side.
M ake settings for prefix or suffix
1. In the Scanner Configuration app, tap the gear icon in the upper right corner.
2. Then tap on "General Settings
3. Now tap on "Prefix Content" or "Suffix Content" and enter the corresponding values.
4. Finally, confirm the entry by pressing "Sure".
Configure action after capturing the barcode
After a successful scan has been completed, a control signal can still be attached to the barcode. There are
three ways to do this.
66 / 74