Husqvarna LC 247 Bedienungsanweisung Seite 13

Maintenance
Do a general inspection
Examine the oil level
Replace the oil (the first time after 5 h of use, then after each 50 h of
1
use)
Clean the product
Examine the cutting equipment
Examine the cutting cover *
Examine the engine brake handle *
Examine the muffler *
Examine the spark plug. Clean or replace the spark plug if it is nec-
essary
Examine the air filter
2
Clean the air filter
Replace the air filter
Examine the fuel system
Clean the cooling fins on the cylinder
Examine and adjust the clutch wire. (LC 247S, LC 253S, LC 347V,
LC 347VE, LC 353V, LC 353VE)
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To clean the product externally
• Use a brush to remove leaves, grass and dirt.
• Make sure that the air intake on the top of the engine
is not blocked.
• Do not use a high pressure washer to clean the
product.
• If you use water to clean the product, do not flush
water directly on the engine.
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
CAUTION:
the air filter down, the engine can
become damaged.
1
If the product is operated with heavy load or in high ambient temperatures, replace the engine oil each 25
hours.
2
Clean more often under dusty conditions or when airborne debris is present. Replace air filter, if it is very dirty.
808 - 006 - 22.10.2021
If the product is put with
Daily
X
X
X
X
X
X
X
3. Hose down the inner surface of the cutting cover
with water.
To examine the cutting equipment
WARNING:
remove the ignition cable from the spark
plug.
WARNING:
when you do maintenance on the cutting
equipment. The blade is very sharp and cuts
can easily occur.
1. Examine the cutting equipment for damage or
cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note:
It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes the
product to stop, replace the damaged blade. Let the
Monthly Each season
X
X
X
X
X
X
X
X
To prevent accidental start
Use protective gloves
13