Samsung POWERbot SR20H9050U Serie Benutzerhandbuch Seite 91

Before use
CaUtion
▶ Insert the dustbin before using POWERbot.
▶ Open room doors before cleaning in order
to have all rooms cleaned and install a
Virtual guard in front of entryway, balconies,
bathrooms, or other areas where POWERbot
may fall.
▶ Be careful with the followings for proper
automatic recharging.
– Always turn on the power of the charger.
– Install the charger where POWERbot can easily
find.
– Do not leave any object in front of the charger.
▶ When installing the charger, do not leave the
cord carelessly on the floor since POWERbot
may get tangled by it.
▶ Do not use POWERbot on black colored
floors.
– The POWERbot may not be able to operate
normally.
▶ Do not pick up POWERbot by the dustbin
holder.
▶ Do not place any objects within 0.5 m to both
sides and 1 m to the front of the charger.
▶ Make sure the charger's charging contact is
not damaged or have any foreign matters on
it.
▶ Do not install the charger in an area with a
dark floor.
– If the floor around the charger is dark,
recharging is hindered.
▶ Move any obstacles that may disturb
POWERbot's movement (such as children's
indoor swing or slides) before cleaning.
CaUtion
▶ Using POWERbot on thick carpet may
damage both POWERbot and the carpet.
– The POWERbot cannot pass over carpet that is
thicker than 1 cm.
▶ Do not use POWERbot on tables or other
high surfaces.
– There is a risk of damage if it falls.
▶ The POWERbot may bump into chair, desk
legs therefore move them away for faster and
efficient cleaning.
▶ When POWERbot is operating, do not lift it up
or carry it to another area.
▶ Do not hold by driving wheels of POWERbot
when carrying it to another area.
▶ Do not put any objects on top of POWERbot
since it may cause malfunction.
▶ Remove any large papers or plastic bags
immediately when using POWERbot since
they may block the intake.
▶ Do not aim the red pointer directly at people
or animals.
CaUtion
▶ Prevent any damage to POWERbot by
complying the followings.
– Do not clean POWERbot by spraying water
directly onto it or use benzene, thinner, acetone
or alcohol to clean it.
▶ Do not disassemble or repair POWERbot.
This should only be done by a certified
repairman.
▶ Always keep the obstacle sensor and cliff
sensor clean.
– If foreign matter accumulates, sensors may
malfunction.
ENGLISH-07
in use
Cleaning and
maintenance