Automatic Charging - Samsung POWERbot SR20H9050U Serie Benutzerhandbuch

Steps to take if recharging is not being executed
Check the installation status of the
charger when:
▶charger is located in a place where POWERbot
cannot easily access
▶distance of the charger and POWERbot is over 5 m
apart
- It may take a long time for POWERbot to return to
the charger for recharging

automatic charging

recharging
Low battery (Lo)
ENGLISH-11
When the battery indicator blinks
during cleaning, poWerbot will
return to the charger to charge itself
automatically.
you may command poWerbot to
recharge at the charger while it is in
cleaning process.
manually charge poWerbot by
placing it on the charger.
manually charge poWerbot when:
▶charger is located in a corner
▶battery is fully exhausted
▶POWERbot is stuck by obstacles (furniture etc.)
▶POWERbot can't climb threshold near charger
(Height of the threshold that POWERbot can climb:
about 1.5 cm and below)
▶when battery indicator blinks and "Lo" is displayed
▶when POWERbot is set on Spot clean or Manual
clean mode