Notes And Cautions - Samsung POWERbot SR20H9050U Serie Benutzerhandbuch

notes and cautions

Charging
Note
▶ If the battery overheats during charging, it
may take longer to charge.
▶ When automatic charging is not working,
please check the followings.
– Turn the emergency switch (on the bottom of
POWERbot) off and on again.
– Unplug the charger's power plug and then plug
it back on.
– Check whether there is any foreign matter in
the charge pins and clean POWERbot and the
charge pins of the charger with a dry cloth or
rag.
– Check for any obstacles such as reflective
objects, chairs, etc. near the charger.
▶ If POWERbot is left detached from the
charger, the battery will drain naturally.
– Try to keep POWERbot being charged on the
charger. (Turn off the emergency switch and
leave the charger unplugged when planning
to leave the house for long periods of time by
going on a business trip or vacation, etc., )
in use
Note
▶ The POWERbot may get caught on
thresholds, etc. during cleaning.
– To restart operation, shut off the emergency
switch, move POWERbot to an area where it
can move easily and then turn on the power
again.
▶ The POWERbot cannot completely clean
areas it cannot enter, such as corners,
between the wall and sofa, etc.
– Please use another cleaning tool to clean them
regularly.
▶ The POWERbot cannot vacuum clumps of
dirt, so some may remain on the floor after
cleaning.
– Please use another cleaning tool to clean them
regularly.
▶ If POWERbot is turned off, power cannot be
turned on by the [Power] button of the remote
control. Press and hold the [Start/Stop]
button on POWERbot.
▶ If the battery becomes low during Auto/
Max clean mode, POWERbot will recharge
and finish cleaning the remaining area after
recharging. (Repeat cleaning frequency:
1 time)
▶ You cannot select and execute Max/Manual
clean mode while charging.
▶ Do not unnecessarily move POWERbot or
press buttons while it is in Auto/Max clean
mode. It assumes that cleaning is complete
and starts cleaning again from the beginning.
Cleaning and maintenance
Note
▶ If you washed the dustbin and filter with water
– Dustbin: Completely wipe out the water.
– Filter: Completely dry it in a shade before use.
caution
▶ Watch your finger when attaching or
detaching the filter, since they may get stuck
in the dustbin's intake.
▶ To avoid blockages by foreign matter, do not
let toothpicks, cotton swabs etc. from being
vacuumed by POWERbot.
▶ If it is difficult to remove foreign matters from
the Power brush, contact a service center.
ENGLISH-22