Daily Use; Automatic Heat Up; The Heat Setting - AEG HK955070XB Benutzerinformation

5. DAILY USE

WARNING!
Refer to Safety chapters.
5.1 Activating and deactivating
Touch for 1 second to activate or
deactivate the hob.
5.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you
activate the hob,
• you spill something or put something on
the control panel for more than 10
seconds (a pan, a cloth, etc.). An acoustic
signal sounds and the hob deactivates.
Remove the object or clean the control
panel.
• you do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the hob deactivates.
The relation between the heat setting and
the time after which the hob deactivates:
Heat setting
, 1 - 3
4 - 7
8 - 9
10 - 14

5.3 The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the control
bar until you reach the correct heat setting.
62 ENGLISH
The hob deactivates
after
6 hours
5 hours
4 hours
1.5 hour
5.4 Activating and deactivating the
outer rings
You can adjust the surface you cook to the
dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the sensor
field. The indicator comes on.
To activate more outer rings: touch the
same sensor field again. The subsequent
indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
When you activate the zone but
do not activate the outer ring the
light that comes out from the
zone may cover the outer ring. It
does not mean that the outer
ring is activated. To see if the
ring is activated check the
indicator.

5.5 Automatic Heat Up

Activate this function to get a desired heat
setting in a shorter time. When it is on, the
zone operates on the highest setting in the
beginning and then continues to cook at the
desired heating setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the
heat setting.
5.6 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
comes on). Immediately