Philips Pixel Plus 32PW9788 Bedienungsanleitung Seite 24

Programming radio stations
You can store up to a total of 50 radio stations.
Automatic programming
Press the ® key on the remote control for
about 3 seconds.
SEARCH
the available stations are programmed
(overriding all former programmed radio
stations).The system will store first the RDS
stations with a strong enough signal, then the
RDS stations with a weaker signal and finally
the non RDS stations.
Note:
- to stop the automatic installation, press the ‡ key.
All stations before the stop, are stored into the
memory.
Manual programming
Briefly press the ® key on the remote control.
&
The current station number starts flashing and
the station name, in case of a RDS station, or
the tuned frequency is displayed.
Hold down the Ò or † key to start the
é
search for a new radio station.The search will
stop on the next radio station and display the
tuned frequency which will eventually be
replaced by the detected RDS name.
Note: briefly and repeatedly press the Ò or †
key to fine tune the frequency if necessary.
"
Use the - or key or the digit keys to select
P +
the station number where you want to store
the new radio station.
Press the ® key to store the new radio
'
station on the selected station number.
( Repeat & to ' to store another radio
station.
Note: To stop the manually installation, press the ‡
key. Nothing is stored and everything is restored to
the radio status just before entering the manual
installation mode.
22
All manuals and user guides at all-guides.com
Give name
&
is displayed and all
é
"
'
Note: To erase a station name:
Select the station number of the radio station
you want to assign a name (for stations without
RDS reception) or to change the name.
Press and hold the b key on the remote
control for about 3 seconds.The cursor flashes
on the first of 8 characters.
Press the cursor up/down to change the
character.
Press the key to confirm the new name.
OK
- Select the station number you want to erase the
name of.
- Press and hold the b key for about 3 seconds.
- Press and hold the ‡ key for about 3 seconds.
- The message appears and the RDS
DELETED
name or the frequency is displayed.