Before You Start; Getting Started; Connecting To Your Wifi Network - Audizio Rimini Bedienungsanleitung

BEFORE YOU START

Please ensure the following is ready:
•
You have a broadband internet connection.
• A wireless broadband router is connected to the internet successfully. The radio supports Wireless B, G and N
connection (Wireless N router can also be used with the setting on B or G).
•
You know the Wired Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA) data encryption code/password. You
need to key in the correct code when the radio is connected to the wireless router for network connection. If you do
not know the code/password, please contact the person/technician who set up the router/network for you.
• The radio can work via Wireless network connection (Wi-Fi connection)

GETTING STARTED

Connect the mains adaptor to the radio unit, one end to the DC IN on the radio and the other end to the mains wall outlet.
Caution: Use only the mains adaptor supplied with the radio. Connecting a power supply with a different rating will cause
permanent damage to the radio and may be hazardous.
The display on the front of the radio will light up and show the Audizio logo:
Then you can select your prefer language on the radio.
It will ask you if you want to Enable the <Check Network when Power on>, it is suggested to choose <Yes>. Then the radio
will always check the available WiFi network automatically.

CONNECTING TO YOUR WIFI NETWORK

The screen below will appear. You can choose <Yes> to proceed to search for the available WiFi network. If your router has
the WPS function, you can select <Yes(WPS)> to proceed.
It will then start scanning the network. After the search is done, it will display a list of the available router.
Choose your router from the list, enter the WEP(Wired Equivalent Privacy) or WPA(Wi-Fi Protected Access) code. If your
network is not enabled with security code, the unit will connect to the router automatically.
Note: The encryption code would have been set up by the person who set up and configured your network.
Please follow the steps below to enter the encryption code of your router using the buttons on the radio:
- Rotate the <Dial/Select> knob to browse the character
6