Omnitronic QuickBTR-5.0 Bedienungsanleitung Seite 12

Battery Status Indicator. Allows seeing the battery status: off when
5
the battery is full, blinks when the battery is low, and is fully lit when
the battery is charging once an active charger is connected at the
USB charger port (2).
6 Unpair Button. Pressing this button initiates an unpairing process.
Stereo Pair Button. Pressing this button initiates stereo pairing,
7
once a mono pairing with a source is already established (only active
if already mono paired with source, and connection LED solidly
green).
2-color status LED. Indicates the current pairing status:
8
- green blinking: ready to pair/pairing with source
- green solid: paired with source, mono replay
- green/red alternating: paired with source, pairing with 2nd receiver
- red solid: paired with source and 2nd receiver, stereo replay
- short amber blinking: pairing memory erased
9 Output Level Switch. Allows to set the output level of the XLR
output (1) to either line level (0 dbu) or mic level (-20 dBu). The
3.5mm TRS output (3) remains unaffected.
Bluetooth Pairing/Unpairing
4
Pairing a single Bluetooth receiver (SINGLE mode)
1) Power on your Bluetooth device.
Note: Before pairing, turn off Wi-Fi on your device and stop any audio
playback.
2) Power on the Bluetooth receiver. The status LED will flash green.
3) Navigate to your Bluetooth-enabled device's setup screen, find "Pro Audio
BT" and connect.
4) When paired successfully, the status LED will illuminate solid green. If no
pairing can be finalized, the status LED will keep blinking green.
Note: If your Bluetooth device prompts for a code, enter "0000".
5) Adjust the volume on your Bluetooth device.
To erase previous pairing settings, press and hold the UNPAIR button for 3
seconds. The status LED will shortly blink in amber, indicating that pairing
settings have been erased. You can now pair to a new device.
12 • EN