Wellis Clement WF00110 Bedienungsanleitung Seite 6

EN
Installing the push button
Replace the tank lid and check the
push buttons.
Adjust the rods as necessary.
Finalising the installation
After the flush button is pressed, there will be a continuous flow of water in the toilet bowl until the
tank is replenished, so as to fill the trap element with the correct amount of water.
Sound pressure when flushing: 85-95 dB
1. Install the toilet seat according to the instruction
guide provided with the seat.
2. Fasten the water connection pipe to the angle
valve permanently. Check for leaks.
3. Apply a suitable sealant between the toilet bowl
and the adjacent surfaces.