Husqvarna K 7000 Bedienungsanweisung Seite 10

This function locks the power trigger and stops the
product. The water valve goes back to closed position.
To do a check of the power trigger lockout
1. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
2. Push the power trigger lockout and make sure that it
goes back when you release it.
10
3. Make sure that the power trigger and power trigger
lockout move freely and that the return springs
operate correctly.
4. Start the product and apply full speed. Refer to
start the product on page 23 .
5. Release the power trigger and make sure that the
cutting blade stops in less than 10 seconds and
stays stationary.
Blade guard and SmartGuard (Optional)
WARNING:
guard and SmartGuard are correctly
attached before you start the product. Do
not use the product if the blade guard or
SmartGuard is missing, defective or has
cracks.
To
Make sure that the blade
1635 - 003 - 20.08.2021