Others - Toshiba Thunderbolt 3 Dock Bedienungsanleitung

Toshiba Thunderbolt™ 3 Dock
Problem
No video on the
monitors attached to
the video output ports
on the dock.
The USB ports are
not functioning on the
dock.
The LAN port is not
functioning.

Others

Accessories of this series of products may vary depending on the model.
Please understand no advance notice for further product improvement,
appearance design and specification update.
The illustration might be a little different from the real product.
EN-28
Procedure
Make sure the computer is connected with the dock.
Check the Using your dock for the first time
in this manual to re-connect the dock to the
computer.
Make sure that the video cable is tightly secured to
the video port in the dock and that the display
output setting of the monitor is set to the correct
mode.
This might be due to that the monitor(s) support
higher resolutions than what the dock is able to
support. Check the
in this manual for details.
If only one monitor is shown, while the other is not,
®
go to the Intel Graphics Control Panel to select the
output for the second monitor.
Only a maximum of three external monitors are
supported.
Check the Using your dock for the first time
in this manual to re-connect the dock to the
computer.
Remove the USB device from the dock and then
reconnect it to a free port in order to ensure that it is
firmly attached.
Ensure that any required USB device drivers are
properly installed. To achieve this, refer to both the
device documentation and the operating system
documentation.
Check the Using your dock for the first time
in this manual to re-connect the dock to the
computer.
Check for a firm cable connection between the LAN
jack and the LAN hub.
Configuring Video Ports
section
section
section
section
User's Manual