VGO INTERNATIONAL TRADE A016-09KR2/G Bedienungsanleitung Seite 27

for the recovery of flammable refrigerants. In addition, a set of calibrated
weighing scales shall be available and in good working order. Hoses shall
be complete with leak-free disconnect couplings and in good condition.
Before using the recovery machine, check that it is in satisfactory working
order, has been properly maintained and that any associated electrical
components are sealed to prevent ignition in the event of a refrigerant
release. Consult manufacturer if in doubt.
The recovered refrigerant shall be returned to the refrigerant supplier in the
correct
recovery cylinder, and the relevant Waste Transfer Note arranged. Do not
mix refrigerants in recovery units and especially not in cylinders. If
compressors or compressor oils are to be removed, ensure that they have
been evacuated to an acceptable level to make certain that flammable
refrigerant does not remain within the lubricant. The evacuation process
shall be carried out prior to returning the compressor to the suppliers. Only
electric heating to the compressor body shall be employed to accelerate
this process. When oil is drained from a system, it shall be carried out
safely.
Fuse parameters of the machine
Type: 5ET or SMT
A. Unit Storage:
1:Unscrew the drainage cover, unplug the water plug, and discharge the
water in the water pan into other water containers or directly tilt the body to
discharge the water into other containers.
2:Turn on the machine, adjust it to low-wind ventilation mode, and maintain
this state until the drainage pipe becomes dry, so as to keep the inside of the
Voltage: 250V Current: 3.15 A