Other Functions; Display Description - Velleman VTBAL6 Bedienungsanleitung

5. Other Functions

5.1. Setting the Auto Power-Off Timer
• Switch on the scales.
• Hold both
and keys pressed to enter the setting mode.
• Set the timer using the numeric keys (timer range from 0 ~ 30 min). The scales will not switch off automatically when the timer is set
to 0.
• Press
to confirm your choice.
Note: This function is only valid when powering the scales with a battery.
5.2. Calibration
• Switch on the scales.
• Hold both
and keys pressed to enter the calibration mode.
• Calibrate the zero point first. The scales display
Press .
• The scales display
• The scales will now display
must be 25% ~ 100% FS. Press
• The scales display
to confirm.
• Remove the reference weight from the platform and press
• The scales will now automatically reset and return to the normal weighing mode. Exit the calibration mode by pressing
calibration error will be reported by

6. Display Description

- - - - - - Overload or overrange
Uncertain value
- - - - - - Weight signal is too small
Zero point is too high
Zero point is too low
EEPROM cannot be accessed
The EEPROM parameters differ from the backup data
The parameter has not been set
Calibration error
Input signal over maximum range
Input signal under minimum range
Capacity-related data display
Voltage-related data display
Totalised data
Piece weighing
Sample quantity
Upper limit
Lower limit
Unload the weight from the platform
Load the weight onto the platform
Calibration mode enabled
Calibration mode disabled
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury
resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
VTBAL6_v3
in the PIECE WEIGHT window. Press
in the PIECE WEIGHT window. Place a reference weight onto the platform. The reference weight
when the displayed value has stabilised.
in the PIECE WEIGHT window. Now, enter the reference weight's value using the numeric keys and press
.
in the PIECE WEIGHT window. Make sure there is no object on the platform.
to calibrate the zero point.
to confirm the zero point again.
4
. A
VELLEMAN