Troubleshooting; Technical Data - Stylies Draco Gebrauchsanweisung

EN | Troubleshooting | Technical data | ERP information

TROUBLESHOOTING

Troubles Possible Causes
The doors or windows are not closed.
There are heat sources inside the room.
Not cool enough The hot air exhaust hose is not connected or blocked.
Temperature setting is too high.
Air inlet / outlet is blocked.
The ground is not level or not flat enough.
Noisy
The sound comes from the flowing of the refrigerant
inside the appliance.
Code «E2» on the digital
Room temperature sensor failed.
display
Code «E3» on the digital
Evaporator temperature sensor failed.
display
Code «E4» on the digital
Water-full warning.
display

TECHNICAL DATA

Below data for your operating reference
Rated voltage 220 – 240 V
Rated frequency 50 Hz
Rated input 950 W
Rated current 4.3 A
Cooling capacity 9000 BTU
Moisture removal (l/h) 1.0
Air flow 300m³/h
ERP-INFORMATIONEN
Sound power (cooling)
Name of refrigerant
Rated power input for cooling (kW)
Rated energy efficiency ratio
GWP (kgCO eq)
2
Energy efficiency class
Energy consumption for double ducts appliances (kWh/h)
Energy consumption for single duct appliances (kWh/h)
Power consumption in thermostat-off mode (W)
Power consumption in stand-by mode (W)
Cooling capacity
Solutions
Close all the windows and doors.
Remove the heat sources.
Connect or clean the hot air exhaust hose.
Reset the temperature.
Clean the air inlet / outlet.
Place the appliance on a flat level.
It's normal.
Contact customer service.
Contact customer service.
Drain out the water.
Value
65dB(A)
R290
0.95
2.6
3
A
–
0.96
–
0.43
9000 BTU
17